Answer Posted / balu
it is onlly used to verify that the system work properly
Is This Answer Correct ? | 1 Yes | 7 No |
Post New Answer View All Answers
How to Calibrate Flammable gas detector in field
What is difference between “Fault Tolerant” & “Fault avoidance” PLC? Application where these system s are used?
Why all the drains(Gland sealing,ESV,Casing inlet etc) are directly connected to the flash tank instead of hotwell of the condensor in the power plant? My Email Id:naba02222@gmail.com
What is the function of solenoid valve in on/off & shutdown valve and why it is not used in control valve normally?
Decibel.
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
hi sir yhis is zahid ali i am preparing for the jspl at oct.4.please send me the recently updated sample paper.
IS there any effect of vortex in low pressure side of the transmiter after the orific in feed water line? if yes then what is the calculation?
What is Span Error
why Fahrenheit unit of moistur analyzer transmitter
what is temperature compensation?
Explain bernoulli’s theorem. State its application.
Using your own examples solve a problem involving normal table. (experimental method and analysis)
In turbine what does term CDP, NI, NH, HSSOC means.
what is difference between fork type and capacitance type level switch. where it is using