Procedure for conduting vector group test on power
transformers.why it is conducted?
Answer Posted / suresh kumar
I also wanted to know this. But as per my knowledge, Same
phase of both primary and secondary are to be shorted
before applying voltage in the answer given by Mr.
Maheshreddy.
Please let me know am I correct?
Is This Answer Correct ? | 14 Yes | 5 No |
Post New Answer View All Answers
I want to ask that is there any relation between current denesity of copper and material purity. also is ther any standard which defines the standard current denesity of material.
Don't you have similar question banks related to Oral Certification Examination conducted by Mercantile Marine Departments / Directorate of Shipping, Ministry of Shipping for Electro Technical Officer?
temp of cast resin 1500kva tx formerwent up to 138.c but came down very fast to about 100.c within 20 mins when load was reduced from 70% to 60%
What is meant by harmonic distortion?
An 8 pole, 50 Hz, 3-phase IM is loaded to a poing where pull out torque will occur. The rotor resistance per phase is 0.3 ohm and motor stalls at 650 rpm. The slip when motor stalls is A 1 B 0 C 13.33% D 10.33%
Explain Circuit Breaker Trip Characteristics in detail.
Lt motor sfu flashing reasons?
Both generator parallel condition shared load equally but one genrator taking ampere more than the other what are all the causes to make like this
Why power genaration in India is at 50HZ while America its 60HZ
What is the difference between earth fault protection of motor feeder with CBCT and Without CBCT ?
is it possible to say motor horsepower number without seeing name plate(when name plate damaged)
what is 30-phase of transformer
how to test power transformer.YNd11
how we findout a ignater is faulty or not?
HOW TO CHECK THE VECTOR GROUP OF A TRANSFORMER YD11?