Interested to Buy Any Domain ? << Click Here >> for more details...
I have 500A load (WHICH IS SEPARATE MDP PANEL),an MCC panel
with 4000A Breaker.Already I have 2500A load.Can I connect
this load directly to the Busbar since I have PROTECTION IN
MY MDP Panel ?
- 4 Answers
- 8220 Views
- I also Faced
- E-Mail Answers
Answer Posted / guest
yes you can
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
Practical condition in 400KV Sub station:- Breaker(open) , isolator(open), Earthing (close) at both end e.g A & B. Now Open A Stn Earthing than Open B stn Earthing (Which have a 50MVA reactor) , AND suddenly show R,Y,B phase 704KV,573KV,118KV respectively. Que is without closing of breaker how it is possible.???? My Whats app No:07621840498 for Further Discussion. Pls experts suggest.
what is the use of piston rings in the engine used for a generator...........
how unidirectional torque is produced in DC motor?
why the check zone and main zone are used for Busbar Protn. scheem?
to hook up ten 50 amp rv pedastels at a lenth of 600 feet from the service what size will my service need to be and the size of wire will I have to run to each pedastel in series??????
what is the difference between directional & non directional earth fault with example please explain.
What is vaccum currcuit breaker.define with cause and where be use it device?
WHY MOSTLY Rph IS USED FOR CONTROL CIRCUITS AUX. SUPPLY ?
what is the difference b/w absolute encoder and incremental encoder?
Is there any abbrevation for STUB in Stub bus protection
Hi I'm doing my MBA(3rd semester).I applied for the post of ET conducted by BHEL the last year.I cleared the written and lost in personal interview.Again I wrote the exam this time and cleared the written n yet to take the personal interview.Shall I disclose in the interview about my studies.What shall i say if they ask about my change from studies to job
How much minimum insulation required between 11kv/3.3kv transformer windings?
high voltage transformer input voltage,current and amps rating..distributed transformer input voltage,current and amps rating...
what is the advantages og idmt relay over magnetic relay??
Pl. give me checklist for installation & commissioning of machine tool.
