I am an electrical power engineer and arranged power system
for a data center, I installed MCB, ELCB and erthing system
TN-C-S.
But some times several ELCBs Disconnect circuits at the
same time! what may be the reason? (the ELCBs are 25A ,30mA)
Answer Posted / shriram.....
ELCBs Disconnect circuits at the power fluctuation time or
any other reason????
Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
While converting delta into star or star into delta ,the three values of resistances remains unchanged .Find out the value?Let In star R1=x;r2=x;R3=x On converting into delta,R12=x;R23=x;R31=x Find the value of x
how we can adjust for three phase motor cold stall time ,hot stall time and thermal register set up?
What is the difference between the relay and the circuit breaker?
which IS or IEC is used for earthing,breakdown voltage of transformer oil, hv/pd testing and all type of electrical testing
What would be the size of wire used for 2 Ton of window A.C?
What is the formula for calculating impedance of transformers connected parallel at fault level 50KA?
My question is whether bellow formula is correct to find bus size for 46kA for 0.5 second & what is RT in bellow formula. formula to calculate the size of busbar to withstand the thermal stresses due to currents with duration of 0.2 sec to 5 sec. Sp = RT( I x I x t) / K Where Sp – is the cross sectional area of bus bar in millimeters. I - is the value of AC fault current. t - is the operating time of disconnecting device in seconds. K – is the factor depending on the material of the conductor, insulation and initial and final temperature. Value of ‘k’ for copper is 143.
why normally Generator rating are between 11Kv to 22Kv?
Why efficiency of generator is higher than motor at a particular load?
Explain cos(theta) and Sin(theta)
how is the incoming cable size calculated for a given current rating of a panel??
what will happen if i connect 12 volt battery with 24 volt battery charger.
What are the various kind of cables used for transmission?
what are the maximum available current, voltage ratings and switching speeds of the power electronic devices thyristor, power mosfet, igbt, and mct?
Enlists the applications of sampled data systems?