What should be the earthing resistance of an industrial
substation and also What should be the house hold earthing
resistance?
- 20 Answers
- 93863 Views
- Jindal, Pharma, TAAT, TATA, I also Faced
- E-Mail Answers
Answer Posted / abhaya raj singh
according to IEEE maximun value of earthing can be 5
ohms.But for a substation it should be less than 2 ohms.
| Is This Answer Correct ? | 17 Yes | 19 No |
Post New Answer View All Answers
Hi Suppose we have a wye/wye transformer which is grounded at both sides,in this situation, do we have ay ground transformer? in other words, ground transformer can do any thing more (while we have nuetral wire in both sides)? As the last question, what about 3rd harmonic? we have two choices: first using wye/delta transformer + ground transformer and second using wye/wye earthed connection.in the former choice, we dont have 3rd harmoonic at the secondary side but what about Yn/yn conection? do we suffer from 3rd harmonic in the Yn/yn connection?
how can service sitting be setted for MCCB?Example for sittings IR (CURRENT RATING),IS(CURRENT STARTING)IO (current operating)?
How to calculate the input cable rating for 10kva ups (3phase input and single phase output and also 3phase output, battery rating 65Ah)provide the formula also.thnx
what is the advantages og idmt relay over magnetic relay??
please send me the previous year's question papers of jindal GET exams
how we calculate electrical load on a building according to area?
best manufacturer for busbar for outdoor switchyard having double bus bar scheme, can any one share technical specification of busbar. 132kv voltage ?
Is it possible to measure the voltage of a battery from a single terminal?
why h parameter are called as hybrid parameter?
Minimum IR value of 1.1 kv grade 3.5c (300, 240,185,150,120,95,70,50,35,25) sqmm Aluminium XLPE cable and 4c (16, 10,6 & 4) sqmm cu arm cable between RY,YB,BR,RN,YN,BN,RE,YE,BE & NE.
What should be the length of transmission line so that we can see/obtain the full sine wave of voltage??
How to Preparation of online test
What is the source of dependent source ?
In control room of our one plant there is a continuously the incoming power goes to PC is vary,means in stabilizer it continuously indicate from high input to low and low input to high. what is the reason and its solution.
IN SINGLE PH TRANSFORMER IF LEKAGE IMPEDANCE DROP IS NEGLECTED ,THE FLUX IN THE MAGNETIC CORE and the lekage flux linking a winding are a)proportional to the applied v to the winding i respectively.
