Interested to Buy Any Domain ? << Click Here >> for more details...
why does a transmitter o/o signal starts from 3-15psi or 4-
20mA?
- 11 Answers
- 18518 Views
- I also Faced
- E-Mail Answers
Answer Posted / vinit paneriya
bcz 4-0mamp in very liner and give corect veriation in
perameter,what ever instrument like plc,dcs etc not working
bellow 3.9 mamp so
| Is This Answer Correct ? | 0 Yes | 6 No |
Post New Answer View All Answers
Whatis the reset ofset and control system in instrumentation
Hi Friends i need Electronics&Instrumentation Engg question papers for BARC written test by coming 20th May 2008 pls post ur use full info to kkumarei@gmail.com. Or for suggestions pls give one missed call to 9962122264
Explain bernoulli’s theorem.
what happen if i increase height of displacer type LT.accuracy or sensitivity are affected.why?
Why boiler chimney area oxyden sensor fixing?
can any one tell me when ongc placement test and its forms is available????/ pls tell me if u know
I installed the smartplant instrument v8, but can not be opened, that always said: "INTools 2007 hardlock no found". So Could you help me how to do for that?
for oil & gas industries which zone is normally preferred? why? give its example?
In bently nevada vibration monitoring system,what is the reason to maintain the Resistance of the probe + extension cable equal to 95 ohm? If possible explain the basic principle of measurement with detail electronic circuits.
To become an Instrument DESIGN engineer, is there any softwares or training to become Instrument Design engineer, plz suggest me, Iam very much interested in designing.
what are the diff. in servo and regulatory control?
what are the definitions of input, output, command & signal according to instruments controlled by PLC using DCS System?
Which Signal hart communicator work? If there any signal change when hart connect while transmitter in line ?
A valve in series with an orifice plate (DP transmitter), is aligned for constant pressure in the pipeline, if there is an error dx, How to align it in process.
I faced several time siemens ps2 positioner automatically getting Chang in it's set point direction after auto calibration So is there any causes biside this or any permissives ?
