Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / abdul nazir
Normally reverse power relay is used for generator side.
when ever we will synchronise the generator with grid or
other generator, immediately we will increase the generator
load other wise the generator will take load from the other
side(grid or other generator). So the generator will run as
a motor.
to avoid these conditions,the reverse power relay will act
& trip the generator circuit breaker.
| Is This Answer Correct ? | 42 Yes | 6 No |
Post New Answer View All Answers
how to calculation increase power factor for single phase
why sielent pole is used only in hydro generators and not in turbo generators
234 MVA Generator 3 phase Short circuit current Values required? Gen set Rating-234 MVA, Gen Voltage-18kv, PF;0.8, Xdv:23.5 %, Transformer Rating-18/380KV, 680MVA,Yndd1 two winding, Step up TR, ZT:35.50 %,X/R 4.33 Gen CB Position, CB open ,Disconnected open, Generator Running Voltage 18 Kv, Bi mistakes generator side earth switch Closed during that time short circuit current level in 3 Phase required, and how to test on site 234MVA Generator Short circuit current,
What is the operating principle of turbo-generator.
Can you used moeller lzm1 mccb in a dc system with 125vdc and 20ka short circuit current , beside is it have 24 or 48 volt shunt ? Beside how long current can through from An MCB shunt contacts? (like Z7-AS 24 V)?
how brushed dc motor operating ?
i want bhel placement paper for electrical if anybody having pl send to my id kavitha867@myway.com immediately
What is class ab operation?
Give details of your interested designation, the post you are interested to serve the company better and explain why you think you can serve the company better in such position if employed?
How many wall/floor flange will i use in bus duct system if we have in our design a 35th floor building.
How Can you do Maintenance of ACB of 2000Amperes
what is the criteria for selecting fuse rating in 1phase, 2phase & 3phase welding sets?
explain different losses in a transformer.
we have earthmat at 110KV substation.we would like to take earth resistance.b some says that by connecting earth megger terminals (C1,P1) at middile point of earthmat (at riser) will cause voltage gradient at other earthmat nods and dont get exat earth resistance.when connecting at end nods will get exat value . is it correct .please explain
What is the loss of transformer of 220kv/11kv, 63/80 MVA and 18.05% impedance
