Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / azhar
cable size is calculated depending up on load ..for example
1 kw load takes 1.8 amps current..if the load is 5kw..than
9amp is the current for amp current the selection cable size
can be opted on the basis of manufature detial like
havells,polly cab..have the range of cable for certain
amount of current we have to selected the cable size on the
basis of manufacture range sheet
| Is This Answer Correct ? | 30 Yes | 10 No |
Post New Answer View All Answers
If there is major % of Voltage harmonics in the system, how can it be control or reduced?
How to arrange a hous hold earthing system to keep minimum earth resistance( below 7ohms).
how 650 volts creates? where is use?
Why do we apply both Differential and REF (HV and LV) protection schemes on YNyn configuration of a transformer?
I need model question papers for RRB section engineer Chennai... Please send to my E-mail Id:- maitheerainbow@gmail.com
Please elaborate th´evenin’s theorem?
Circuit diagram of tube light without starter using electrical choke
What are test values for an 63 KVA and 100 Kva Distribution Transformers for the following typical tests 1)Magnetic balance 2)Short circuit test 3)Open Circuit test 4)Vector group confirmation test .please give me the standard values for all the above tests.
how to control the speed to switched reluctance motor
In electrical locomotive engines, the DC series motors is being used as traction motor. But in new engines like in WAP7 & WAG9 the 3-phase squiral cage induction motors has replaced them. So can someone tell me the advantages of induction motor over dc seris motor in engines points of view....???
How to design the NGR Resistance
Can a generator runs after getting 1st stator earth fault.
How can we calculate the motor frame sizes?
how can calculate resistance box for 15 kw, 6 pole, RV-230, RA-42 motor
What is the unit audit? if our Max demand is something and we found much more unit then how to improve our max demand?
