Two 11 kv lines are feeding to common bus in a
substation,I have one set of CT & PT(3ct,2pt), How can I
measure both lines power using single set.
Answer Posted / sreejith
connect 2 cts to any 2 phases and 1 pt to one of the 11 kv
line.this will give power by 2 wattmeter method. connect
one ct to any one phase of bus and connect one pt. From
this u can get power in bus as bus will be balanced and
total power will be 3 times one phase power. If u deduct
power in one 11kv line from power in bus u can get power
from 2nd 11kv line
Is This Answer Correct ? | 0 Yes | 3 No |
Post New Answer View All Answers
hello friends..... any one have papers or any study materials?sail ,hpcl...?
comparision between ACB and VCB
Name of the relay of low lub oil presuure in DG sets
at work we have a 3 phase motor but on testing one phase isnt getting a reading. it runs 24 hours a day all week. stops and starts well no noise or heating. the phase isnt down to earth.is it just a bad meter reading or not? phases one and three came up with a resistance reading of 0.4 but phase 2 couldnt get anything shows up as open circuit.
Explain about how is it working Earth fault'relay and wahts the resistance value of earth bed
Explain Energy and Power signals?
What is Instantaneous Earth fault relay,how will work
what is the benefit of floating our DC source? if i have two floating DC source of which 1 has a ref voltage of -21VDC and the other of -18VDC. can it be connected in parallel to share a common ref voltage? if not, how do i make both sources to be of common ref voltage? tks
what is the effect of connecting three phase supply lines to three phase auto transformer output terminals through a fuse of 10Amp and a circuit breaker (MCB). Is this connection permanently destroy the transformer?
hello friends this is krunal here.. i have applied for he officer train in hpcl electrical stream.. any one who have applied before for electrical stream please help me out.. post ur reply to my mail id: krunal_airforce@yahoo.com.. any tips, old questions for paper or any help will do.. plz help me.. your faithfully, Krunal Darji
H.t motor 6600 volt to same motor lt supply 440volt supply applyed to h.t motor to effect....
What is maximum power transfer theorem?
Show the schematic arrangement of diesel power station layout and give its principle of operation.
what is the range of maximum DOL and SDS can be use for pump and fan application
What are capacitive,resistive,inductive surge absorbation? What is ferranti surge absorber? What is lagrangian cost? What is Px operator?