What are the difference between C-Curve and D-Curve for
MCB's.
Answer Posted / g.venkat reddy
MCB are classified as
B,C,D,K curve type
intant..trip current,
C....2-5 times the rated current.(motors,Ltg,inductive
loads)
D....10-20 times the rated current.
(Drives,computers&capacitors)
| Is This Answer Correct ? | 15 Yes | 109 No |
Post New Answer View All Answers
if 6 earth pit value is 1.5 ohm then what should be the number of earth pit to make the value .8 ohm
State the formula for overall efficiency of thermal power station
1.how many types of relays? 2.difference between ATS& STS?
What is the comparison between 30mA DP RCCB and 100mA DP RCCB and can replace it against 63A MCB
3phase motor can be used as a Prime mover for alternator.
How to identify the start and end of 3phase 12 lead motor if U1, U2, etc numberings are lost or erased.
An impedance of 100 ohms resistance and an unknown inductance is connected across the capacitor. The resulting impedance is a pure resistance of 500 ohms ifω = 10^5 rad/sec. calculate the values of inductor and capacitor.
Why are the cores of large transformers built up of circular transactions ?
How much inductance or resistance require as a starter in series with induction motor of specific capacity(e.g. 5 hp) ? What is formula for it ?
How to calculate the External Resistance required for 60HP slipring motor in case no any data of the Motor is available???
A 11KV, 1200 A breaker combination fixed in a cubicle for HT motor.Is normally for 11 KV motor fuse is using? if Yes, What range fuse is required?
Is vtg is controlled by the resistor? if else how much?
What is transient Phenomenon?
What is the formula to calculate the rating of a three phase air circuit breaker
what is the stear deltaprinceple?