Interested to Buy Any Domain ? << Click Here >> for more details...
what will happen when choke in tube light circuit was not
working???
- 7 Answers
- 17097 Views
- I also Faced
- E-Mail Answers
Answer Posted / pavan
Choke will increase the voltage which it ionises the gas in
the tube.With out choke the tubelight will not glow.
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
What is effect of over voltage and under voltage on ACB
block diagram of 2 ups system connected in parallel mode?
how does high earth to neutral voltage affects electronic circuit?
Mention the disadvantages of low power factor?
when we design electrical schemes of 11/.415kv distribution..wen and were should we show the relays??what is the function of it?for example..we place EFR Relay CT between transformer neutral link and transformer earth.Like this what are the other type of relays we should use?why?where?Explain please..Thank you
how we calculate electrical load on a building according to area?
What is the problem of internal failure in ship engine telegraph system norcontrol?
how do we calculate length of starting time and repeated starting of a direct online starter?
how many safety really of DG sets.
what will happen if frequency is below 50 hz?
sir am giving jspl exam on 19th oct . i belong to eee, so plz send previous question papers ..........to dis id abhilash203@gmail.com
aternator every parts and its working
I need to connect a synchronous generator to the grid using automatic synchronization and two circuit breakers (one for synchronization, one for end connection to the grid), how to determinate the required diameter of the cables?
what are the standard IR values should be of R-E, Y-E, B-E, R-Y, Y-B, B-R of VCB in closed condition and in open condition for 500KVA & 1000KVA transformers. and what is the acceptable range when tested by 5000V megger.
i have a 4 Mva transformer 34.5 kv / 480-277 v and i used 2 parallel 3200 amp bus duct for the secondary feeder using 3 ply of bus bar ( 3/8" x 5" ) as a common where the flexible link terminated and 6300 amps breaker for the main, the lower bus duct reaches 70 degrees and the upper bus duct reaches 55 degrees when i used thermal scanner. why the temperature is not balance when the load reaches 3600 amps.
