what is difference between start imitation and start
interlock for 3 phase motor protection ?
- 2 Answers
- 6928 Views
- OPS, I also Faced
- E-Mail Answers
Answer Posted / shivani
Start limitation means no. of start this is bercause if
consecutively u start the motor the motor got heated&
thermal conductivity will dec. .not goo for its health.
Start interlock means
frequency,voltage& powerrequirement we can control by
different relay so. after fullfilling those constraints
only it should start for giving poptimal performance.
| Is This Answer Correct ? | 1 Yes | 4 No |
Post New Answer View All Answers
why the frequency and voltage in india is 230v and 50HZ. when compared to USA say 110v and 60 HZ.
if 6 earth pit value is 1.5 ohm then what should be the number of earth pit to make the value .8 ohm
How can calculate the rating of a alternator for a given specific load with formula
What is nichols chart?
SIR, GIVE ME OPGW SAG CALCULATION FORMULA I AM DAE ELECTRICAL. THANKS
what is the significance of cabability curve of alternator
Can anyone tell me some hints about what type of questions are asked by the interviewer by an Electronics engineer when company is installing an IPP and wants a team of engineers?
hi friends ,iam working as genset AVR service engineer in electrical field from past 2 yrs throughout india . i plan to shift in some other job without travelling in same field because i con't travel,i dont know what i do for that so please guide me what job is suited for me,how i can serch the job please anybody helpme iam totally confused
what happen when we add mentos in cold drink?& why?
I want to know all basics of electrical engineering
A 100 kVA , 400 v/250 kv testing transformer has 8% leakage reactance and resistance on 100 KVA base . A cable has to be tested at 500 kv using the above transformer as a resonant transformer at 50 hz . if the charging current of the cable at 500 kv is 0.4 A find the series inductance required . Assume 2% resistance for the inductor to be used and the connecting leads . Neglect dielectric loss of hte cable . what will be the input voltage to the transformer ?
What is the difference between a 3 winding and 2 winding Potential Transformer
Where should the lighting arrestor be placed in distribution lines?
How to configure the drives in PLC, through Profibus commnication. And to how to address it?
What is the pro & con of having 11kv & 33kv incoming, and what is the adv & disadv. of converting from 11kv to 33kv.
