Interested to Buy Any Domain ? << Click Here >> for more details...
why does mA signal preferred for signal transmission?
- 12 Answers
- 25549 Views
- Emerson, I also Faced
- E-Mail Answers
Answer Posted / daher
THE ELECTRICITY SPECIFIED AS HIGH VOLTAGE-MEDIUM VOLTAGE-
LOW V.-HIGH CURRENT -LOW CURRENT.mA is used in control
signals $communication ,computers......,
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
how to calibrate steam control valve in steam turbine
How does temperature bath work? How does coil gets heated only by applying some current?
(1) In turbine, what does term CDP, NI, NH, HSSOC, means. (2) What is the purpose of LO overhead tank in turbines.(3) An equipment is certified for EEX, IA, IIC,T6, what do you under stand by this.(4) what is SURGE, and how it is prevented, what is the purpose of bypass valve across AS valve.(5) Give 2 application of quartz crystal used for process parameter measurement.(6) what is meant by cold float of compressor shaft. (7) state four different types of flow measurement. For gas flow measurement mmscfd is the common unit. Expand the unit and specify significance of word S in the unit.(8) what is meant by Gap voltage, in vibration measurement. Normally how much Gap voltage is set and state the reason.(9) what will the new flow factor if D/P transmitter is Re-Ranged from 25” wc to 50” wc.(10) what is the usage of QDV & Volume booster.
what happen if i increase height of displacer type LT.accuracy or sensitivity are affected.why?
State some of balance principle’ advantages?
How to do gas analysers calibration in AUTO and Manually by using zero and span gas?
what is difference between HOT permit and cold permit
Calibration procedure for water rotameters
Can please tell mi about SIOS, PRM, SERVER, and what is the diference between PIN LAN, PCS LAN,APC Server, and please send the Doc if possible for referance,mail id patil_amit17@yahoo.com
principle of automatic votage regulator
What are the uses of orifice plates?
why fuse block is not used for AI signal?
How we calculate orifice plat size???
What is the use of single seated valve?
How does your previous experience relate to the job you are applying for ?
