Interested to Buy Any Domain ? << Click Here >> for more details...
If I want to use capacitor banks at HT (11 KV) side for
maintaining power factor then which type of capacitor
should I use? Plz give me the specification?? (I am using
1250 Kva transformer (11 KV/433V)).
- 2 Answers
- 10677 Views
- I also Faced
- E-Mail Answers
Answer Posted / zahid
Kindly note that capacitor banks are usually installed at
distribution sides not generating ends. This is due to the
fact that capacitor banks provides reactive power to the
network to improve power factor. If we implement capacitor
bank at HT side we have to increase cable cross sectional
area and Trafo copper winding. If you want specs then email
me at zahid.mushtaq@tuwairqi.com.pk
| Is This Answer Correct ? | 16 Yes | 5 No |
Post New Answer View All Answers
how can calculation ate Amps for cabel. Ex-for 1sqmm wire hou many amps we can draw
What is the use of lag compensator?
XYZ
How to derive detailed design of Suitable bus Bar for 100A for 6.6KV?
This is reqd for a 1MW Solar power plant..We have 2DC outputs from the solar panels Connected to 2INVERTOR panels.. Output from invertor is 3ph,280v,500kva,50hz.These are connected to individual ACB.This has to be stepped up to 11KV ,1250KVA SYSTEM.Now can I use (1) one more ACBTO GIVE A COMBINED OUTPUT OF 1000KVA,280V & STEP UP THE OUTPUT BY USING a single two winding 3 ph transformer 11kv/1250kva. or (2)use the two outputs and connect to one three winding transformer of above rating..Pls suggestwith details.
How to measure the earth resistance value in a concrete pavement(flood light area)?
How to calculate the time setting for star connection in star delta starter? For example 10KW 3PH Induction motor.
plz send me Bhel, Mahagenco, sbi previous exam paper for electrical engineer on my email-id kambali_smita@yahoo.co.in
what is d check in dg 1500kva
what are the industrail measures to over ferranti effect? how would the ferranti effect the power system if those remedial mearsure arent taken? how often does this effect occurs in real power system?
What is cut-off rate?
If we use 250A MCCB as a incomer in Control panel for a fault level of 50kA for one second ,assuming temperature rise from 85 Deg. to 100 Deg , Then what will be the Aluminium Bus-bar size for 250A MCCB? Explain in detail.
Why do we need a separate control desk & PLC control panel in Boiler plant or coal handling plant? Can we provide cost effective Control desk cum PLC panel. Is there is an specific need for control desk.. kindly advice.
i have faced a problem in ro plant grunfos make bm30type pump it is 22kw pump. We start this pump using siemens 3rw 4423-ibc44, 30kw softstarter but this soft starter will frequently failier so we planed to change dol starter. So pls tell anybudy its possible or not.
For group 1 , 2 whather i have to prepare my technical or general studies etc? and im graduate in ee engg. for wht posts im eligible for? please tell me!
