thermal power station operation in general
- 11 Answers
- 30178 Views
- AJ Square Inc, Jindal, NTPC, I also Faced
- E-Mail Answers
Answer Posted / gopinath.v
The water is obtained in the boiler and the coal is burnt
so that steam is obtained this steam is allowed to hit the
turbine , the turrbine which is coupled with the generator
generates electricity ...
| Is This Answer Correct ? | 88 Yes | 7 No |
Post New Answer View All Answers
If we need4× 50mm sq cable but it's not available so we can pull 4×25mm sq 2cables
Whether power factor should be high or low? Why?
i have to install a HT panel, what components, I have to use in this and what will the diagram of that diagram,please tell me each and everything.
What are marginally stable systems?
solar inverters was not connected to the nuteral link .this nutwral possible to any other systems
What is the principle of HIGH SPEED DIRECT DRIVE MOTOR ?
For high frequency application we use which transformer?
in single phase converter, the no.of scr's conducting during overlap a)1 b)2 c)3 d)4
How you give clearance to a spare feeder.
Can you please explain creepage distance in detail, for a 6.6kV cable head what must the distance be and how do you determine it?
In a carnot engine with an efficiency of 40%, the heat rejected to the sink at 27 C is 60 kJ, then the heat supplied in kJ to the engine by the sources is
in non technical way how can u define POWER FACTOR??
A ray hit a smooth regular surface at an angle of 20 from the normal. Calculate : 1. The angle btw the incident and reflection ray. 2. The angle of deviation.
What is the breaking capacity of transformer and how can we calculate the breaking capacity of tranformer
how the synchronizing is obtained at bus couplers in grid substation? (because there we cannot change the frequency in one of transmission lines like in generator synchronization)
