Interested to Buy Any Domain ? << Click Here >> for more details...
why 4-20 mA signal is preferred over a 0-10V signal
- 17 Answers
- 76626 Views
- Sofcon, I also Faced
- E-Mail Answers
Answer Posted / elsayem
in 4- 20
we can find if the process variables give zero because zero
is indicate 4ma
but in 0 - 10 if the process give zero we can not know
because the signal also 0v
| Is This Answer Correct ? | 22 Yes | 11 No |
Post New Answer View All Answers
Why upper weighing limit of electronics balance is 90% of the total weighing capacity?
how to calibrate 0- 150 psi presure gauge by dead weght tester
flow transmeter accuracy 0.075% of full scale & find ucertainty is 0.025 % so what is maximum limit band of uncertainty
With N nodes and B branches what will have a network ???
What is mean by analytical instrumentation?
where proximity sensor installed on tank in loading arm application
How to calibrate the flow transmitter
what are the selections available in configuring a burnout protection of a controller? thanks
In my company plc based winders are operated. one day there was a data transmission failure alarm shown on pc. as per sir instruction we have reset master plc but winders were not triped and alarm gone. so what master plc do?
control panel design guidelines
what is IEC code in cables & how to selecting cables?
What is the difference between conductive lined pipe and conductive unlined pipe? Why do we see that?
How to find out the current of two motors having same power consumption but different RPM?
Senior engineer's please help me, what is Loop Checking and Loop test? and write difference also? soon urgent
Describe how to use megger to measure the earth resistance and insulation resistance
