Answer Posted / satya.elect
C.T means current transformer and it is a stepup transformer
P.T means potential transformer and it is a stepdown
transformer.
Is This Answer Correct ? | 20 Yes | 26 No |
Post New Answer View All Answers
what is rocking arrangement in arc heating
how do i commission a distribution transformer knowing all its ratings and transformation ratios?d
What is the general system requirement of alternator?
Can any body tell me about INNER SHUNT COMPOUND MOTOR diagram?
RESPECCTED SIR/MADAM- I AM PRERING FOR SECTION ENGINEER (ELECTRICAL) RRB CHANDIGARH PLEASE SEND ME SOME PREVIOUS YEAR QUESTION PAPER OR MODEL PAPER.MY EXAM IS ON (30- NOVEMBER 2008).I AM VERY THANKFUL TO YOU. FROM- HARENDRA SINGH YADAV
If symmetrical fault occurs at the terminal of a synchronous motor then how the motor will act...explain it..
HOW TO SET THE EARTH FAULT SETTINGS IN ACB????????????
how to calculte capacitor range for single phase induction motors??pls tel
I want to make street light with solar system ... What may I do for procedure and how much of estimation for each material ... If any one knows guide me and inform this id : aravindd7@gmail.com
what are inductive and capacitive voltage transformers.what are their applications
why we use condenser in the thermal power plant, althrough the same vapour will be again heated
How to calculat the ratio of HT\LT in energy meter
WHAT IS LOAD CELL
how rectifier transformer work in electroststic precipetatore(esp?
Can anyone provide with a SLD for HT panel installation for a 33KV line and distribution end has three 1.5MV transformers. Is it suitable to use OCB or VCB and also provide me the suitable rating and its connection diagram.