Interested to Buy Any Domain ? << Click Here >> for more details...
what happens when ac supply is given to D.C motor.
- 17 Answers
- 31867 Views
- I also Faced
- E-Mail Answers
Answer Posted / sam khanji
The Motor will run only on the positive side of the Ac
wave .so it will run and stop then run again and stop again.
but if the volume of the AC is high, then the winding will
be burned due to the high frequency exposed to
| Is This Answer Correct ? | 5 Yes | 20 No |
Post New Answer View All Answers
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
What products have you designed which have entered high volume production?
how to find out cable size if load is 2800 watts, 230 volts AC supply and load distance is 1800 meters
Give details of your interested designation, the post you are interested to serve the company better and explain why you think you can serve the company better in such position if employed?
I have a CT meter with ratio 60/5. The meter reading of previous month was 3290.49 and that of current month was 3797.26. How many chargeable units as per normal meter should be my reading.
why does the magnetic balance tests at transformer?
Is there any specialised book to refer about fault level calculation both in MV and LV side??
How to convert 2 phase to 3 phase electricpower in induction moter?
What the formula for calculating no.of earthings & size of earth strip for 100mX90m shop.
Why do we pefer VCB over OCB?What are the advantages of VCB over OCB?
Minimum IR value of 1.1 kv grade 3.5c (300, 240,185,150,120,95,70,50,35,25) sqmm Aluminium XLPE cable and 4c (16, 10,6 & 4) sqmm cu arm cable between RY,YB,BR,RN,YN,BN,RE,YE,BE & NE.
A generating system will have a total capacity of 300 MW. Find the probable forced outage when the capacity is supplied by two 150 MW units. The operating probability of all units is P=0.98 and forced outage probability rate Q =0.02 .
i have 500 amp inductive load of motors ,,,pleas tell me how can i calculate for capacitor bank for improving my power factor to 99 .....calcullations for capacitor bank,,,,
Why CBCT rating is 50/1A
th how could we differentiate between armoured copper and armoured aluminium cable what is the basic application? why we prefer the armoured copper as compared to armoured aluminium.
