Answer Posted / surya

High Ruptured Capacity Fuse

how the testing of protection CT Testing done through Primary injection kit please describe in detail procedure...

2225

---

Alternator rotor earth fault relay circuit

2078

---

how to commissioning the genset with amf panel?

2405

---

Define availability (operational)?

1150

---

What are the advantages and disadvantages of the dc motors?

1133

---

exolain the star delta connection

2678

---

What is “pu” in electrical engineering?

1139

---

How to calibrate or test an LT Air Circuit breaker 440 volts, 35 KA, 800 Amps ?

2604

---

HELLO SIR, IAM PREPARING HPCL EXAMS. SO PLS SEND MATERIAL OF HPCL ELECTRICAL ENG..TO VIJAY_8888@YMAIL.COM

1870

---

I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?

1806

---

Is there a possibility to use such a treshold voltage for the NMOS part of a CMOS circuit that during the switching it will start conducting only after the PMOS part will be already closed, by this eliminating the leakedge current? Please note, I'm not asking about the well bias in standby mode, but about the "antileakedge" measures during normal operation.

2072

---

An 8 pole, 50 Hz, 3-phase IM is loaded to a poing where pull out torque will occur. The rotor resistance per phase is 0.3 ohm and motor stalls at 650 rpm. The slip when motor stalls is A 1 B 0 C 13.33% D 10.33%

1936

---

how is the incoming cable size calculated for a given current rating of a panel??

1935

---

what is maxemo work permit procedure

2201

---

list the type of vfd? wich is sutable for heating kiln?

2092

---