Interested to Buy Any Domain ? << Click Here >> for more details...
Why in DC drive u r using in Klin operation in Cement Plant?
- 7 Answers
- 22719 Views
- I also Faced
- E-Mail Answers
Answer Posted / ashok kumar
in DC motor speed control is very easy and for kiln
operation it required high starting torque , so we go for
dc motor but at the present scenerio we go for Ac motor
because initial cost of dc motor is very high and its
maintenance cost is also high.
| Is This Answer Correct ? | 34 Yes | 2 No |
Post New Answer View All Answers
how did the testing of protection relays done through current injection
WHY TERTIARY OF POWER TRANSFORMERS IS LOADED WITH EQUIPMENTS LIKE CT,PT,ISOLATOR AND CB
Why only sinusoidal ac voltages are generated?why not triangular or sawtooth?
what is meant by 2 within a star in a voltmeter dial?
Can a generator runs after getting 1st stator earth fault.
Why current shoots up in the secondary on the knee point voltage during saturation test of CT? How core saturation effects the secondary current (while the primary side is open)? What the logic behind this?
what is the formula of starting current of 3phase and 1 phase motor???
What is meant by stator?
Please help me regarding my one concern. - During earth pit testing we noticed that the Clean earth pit and dirty earth pit showing continuity (Resistance value - 5ohm) . I want to know that if both earth pit have separate location and there is not internal looping between PIT then why such continuity is showing on it . Because of this issue the field side all earthing point showing short. In PLC panel we are providing two types of earthing cable which is coming from separate earth pit (Clean and Dirty earth pit) because of earth PIT showing short our PLC is not complying spec . please help regarding this issues.
What is the difference between rated and per unit in transformer?
what is meaning of 230volts ac 50hzs ac supply is it rms or maximum to getting ac 230v what amount of max voltage they will send
Can you any one explain application of buccholz relay operation and pressure relif device operation of power transformer
WHat is the requirement of installing FAST ACTING EARTH SWITCH in GIS and how is that integrated with protection system. How and when does it operate?
what is the k var ratting of 1250kva
what is Fault level? why it is calculated? how will u decide same for our plant?
