Interested to Buy Any Domain ? << Click Here >> for more details...
THE 40 MW OF POWER FOR 220 V III PHASE POWER CONNECTION
REQUIRES HOW MANY KVA POWEER REQUIREMENTS
- 7 Answers
- 11326 Views
- Chartered Accountant, I also Faced
- E-Mail Answers
Answer Posted / v.s.narayanaswami
THE ABOVE FORMLA APPLIES FOR CONVERSION OF HP INTO KVA AND
THE CORRECT CONVERSION FACTOR IS 0.764.
THE REQUIREMENTS OF 40 HP CONNECTION CONVERTED INTO KVA
APPLYING THE FORMULA IE 1 HP = 0.764 KVA IS 40HP/0.764 IS
APPROXIMATELY IS 52 KVA.
HENCE UR CORRECT REPLY IS SOLICITED FOR ARRIVING AT THE KVA
DEMAND FOR THE ESTIMATED 40 MW OF POWER CONNECTION
REGARDS
V.S.NARAYANASWAMI
B.COM(HONS), M.COM, F.C.A
| Is This Answer Correct ? | 2 Yes | 12 No |
Post New Answer View All Answers
i have been tasked with a design of protection, metering and control(PMC) relay panel extension to accommodate all PMC relays.There is an already existing panel where this one will be built.What are the design aspects for this kind of project? thank you.
What is meant by reactance voltage?
What are the advantages of instrument transformer?
Type of motor stater detail and working detail
If I want to buy a new Xformer for my plant what are the main parameter will I need to check?
DIFFERENCE BETWEEN NORMAL TRAFO AND THRISTER TRAFO?
How will you define capacitance?
i am an maintenance engineer. one distribution board have 5 feeder. recently its ELR trips frequently, but it take some times after trip( 10min,20min..)but 3 feeder no load. two feeder only loaded. i checked one feeder IR value all values are above 50Mohm.but B phase to Earth is only 9Mohm.any problem about low value
What is mean by STUB protection?
why are distributed windings generally used in alternators?
1) Explain why we don't link the two earthing system ht and mv on a pole mounted transformer sub-station.
What is the basis for framing the rules of block diagram reduction technique?
If a current -8+6sin6t is flowing three ammeter, one is a centre zero PMMC meter, one is true rms meter and one is moving iron meter. What are the reading of these three meter respectively?
Is there any guideline say about display of earthing value near to earth pit
Why two phase welding machine is used instead of three phase welding machine.
