Answer Posted / a.muthu kumar,vacon

Acually the question is for using only one PB for ON and
OFF the motor, not one PB for ON and one PB for OFF.

[ PB M2 O/P ]
[-----[ ]--------[/]--------( )----]
[ i ]
[ O/P i ]
[-----[/]---i ]
[ ]
[ PB O/P M1 ]
[-----[/]----[ ]-------------( )---]
[ ]
[ PB M1 O/P M2 ]
[-----[ ]----[ ]-----[ ]-----( )---]
[ ]

hii my name is sujith...i am preparing for HPVL GET 2010... so ,,,pls help me by send any previous questions or material to my site.....(Msujith_12@in.com) thank q

1937

---

selection criteria of control valve? and selection criteria of actuator explain in brief?

4127

---

WHAT IS THE CAM POSITION IN CONTROL VALVE POSITIONER ? WHY IT IS USED?

1045

---

what is dc moter.

2284

---

Question on maha cement

778

---

can any send me a forbes marshall dtron 316 manual

2004

---

How to Calibrate Temperature Switch in field

1360

---

Explain the working of an enraf level gauge.

1143

---

1.what is controller proportional gain 2.what is the controller intergral action time. 3.A proportional plus derivative controller that has a proportional band of 20% and a derivative action time of 0.1 minutes. Construct the shape of the output waveform for the triangular input if the input rises and falls at the rate of 4 units per minute.

2735

---

use of split range ? where it is used ? in which control loop it is used ?

2011

---

What is rang ability?

2389

---

What is the main difference between Cavitation and Flashing?

14443

---

where are following valves are applicable to install. can any valve be installed any line. globe valve butterfly valve boll valve gate valve

1827

---

What are the interlocks we have to check during the start up of LP/HP compressor?

2041

---

why we us isolation barrier in hazardous area how it works to protect the area and please clarify its current flow.

1996

---