Interested to Buy Any Domain ? << Click Here >> for more details...
THE 40 MW OF POWER FOR 220 V III PHASE POWER CONNECTION
REQUIRES HOW MANY KVA POWEER REQUIREMENTS
- 7 Answers
- 11324 Views
- Chartered Accountant, I also Faced
- E-Mail Answers
Answer Posted / reshi
If we assume the power factor during motor running as 0.85.
Then the calculation will be 40MW/0.85= 47MVA.Answer.
| Is This Answer Correct ? | 10 Yes | 4 No |
Post New Answer View All Answers
draw the restricted earth fault protection circuit install on power transformer and identify its parameters and draw C/C curve of it
i have 90kw motor.so i choose connect cable .please what is parameter checked so please give to formula
How select ELCB for 32amp. socket having quantity 12Nos. We have to do this wiring in PLANT. Please Also explain the incoming cable specification.
is it necessary to earth the rmu before cutting off the transformer winding?if yes why?
hi, in the event earth grounding is not available in a project, is there any other way to make the elcb work? fyi, i have an instant water heater (6.5kw) installed, however if there is grounding in the heating element inside the heater assembly, i will get grounded. thank you in advance to those who will answer my question.
What are marginally stable systems?
Hi My dear all Friends, There is a question regarding HVAC Engineering and widely used in Power Projects. Question- What is the diffrence Between REF, SEF and Differential Protection....???? Where REF - Restricted Earth Fault SEF - Senstive Earth Fault.
What is different between Circuit breaker and Isolater?
technically, what is the reason behind starting the motor star the delta connection .. and what other ways to do this rather than using " star-delta transformer"
if there are six generators (3 gas CATT, one Jenbacher o1 MW each, and two nos Diesel 01 no 01 mw other 0.65mw EDGs ( say), 3 CAtt gas set have identical pole pitch,01mw EDG and Jenbacher gas Set have different pole pitch, how their power connection can be done to connect a common bus bar during installation. in short, how different pole pitched generators power connection can be done to connect a common busbar system through generators incomer ACBs.
could you measure current in parallel?
where are the circulat the diesel in DG parts name with pictue
while doing high voltage test on 11kv/433 distribution transformer why we only give 28 kv on hv side and 3kv on lv side for power transformers what is the value what factors it depends
What is the function of auadag in a cro?
Why use the vcb at high transmission system ? Why can’t use acb?
