Interested to Buy Any Domain ? << Click Here >> for more details...
Where there is voltage,there must be current.Is this right
or wrong??
- 10 Answers
- 11559 Views
- I also Faced
- E-Mail Answers
Answer Posted / punniyamurthy.g
wrong.
because for a current flow, the circuit should be closed
otherwise there is no current flow takes place
eg: battery.
when the voltage source is open then there is no flow of
current.
if we connect a load to a battery then current flow takes
place.
| Is This Answer Correct ? | 20 Yes | 0 No |
Post New Answer View All Answers
i want some interview related questions with their answers which can help for attend the interviews...
1.ZEBRA conductor(large size) 2.KUNDHA conductor( small size ) 3.panther conductor(very small ) 4.lepard conductor (very very small)
DESCRIBEPNEUMATIC SYSTM OF ASH HANDLING PLANT
what is the meaning of WYE and DELTA in Electric meter?
How do you determine the size of transformer radiators in a transformer?
What it the purpose of parallel phasing transfomers??
1 “earthing” for bonding of equipment and circuits to common plant earth electrode potential, 2 “protective earthing (PE)” when this bonding is required for personal safety provisions 3 “grounding” for interference suppressing bonding of screens, sys-tems with ground level 4. low-impedance earthing ? 5.primary earthing system and secondary earthing system what is that? 6.earthing electrode or mesh net earthing electrode ? very confusing , simple but very informative help required ? i will be very very thankful to you guys.
when will be the iocl interview results i faced interview on 8th september 2008 iam from electrical branch i faced interview for the post of electrical engineer??????????????????????//
we have 2.2kw,Y,3000rpm motor but 6leads found in TB what happen if we connect in delta?
-How do you select cable size for a given load at a given distance from source of supply. How do you find voltage drop.
WHAT IS THE WORKING PRINCIPLE OF A GENERATER.how is a GTG (Gas TURBANE Generater) working.plz explane
with 3 phase board on a 63 amp rcd is it ok to have 6 electrical showers 2 on each phase and what problems could happen
While testing a ZCT what parameters have to check or measure?
How to calibrate or test an LT Air Circuit breaker 440 volts, 35 KA, 800 Amps ?
How can we choose the rating of submersible motors
