Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / malayappan
Term Flash has no connection with moulding process. It is
acually connected with closed die forging operations. When
a component is formed using an upper and lower die in a
forging press, the die desing has flash(or the die has)
where in excess metal goes.
| Is This Answer Correct ? | 3 Yes | 3 No |
Post New Answer View All Answers
Low water in boiler drum is unsafe because it may result in overheating of water tubes in furnace. Why it is unsafe to have high water condition in boiler drum ?
if any one attended caterpillar placement pls send the model questions and the question pattern.....
What is a vee used for on the vee block?
why boiler is closed system ?
Explain the principle of Suizer Fuel oil injection pump
"When you will install a new piston ring, what will be the position of it?"
how to design a crankshaft?
how to solved the crictical problems in d. g. set
What are the causes of liner high temperature?
How to create a Button use visual basic in Excell 2007 and how to hyperlink the button ?
why with the increase of pressure latent heat of steam decreases?
Which is the welding process you have carried out in workshop?
How the net work to drive a compressor and its volumetric efficiency behave with increase in clearance volume ?
In terms of electrical enhineering, give a detailed explanation of the "earth fault loop path"
How much is 1 kn in kg?
