Answer Posted / banibrata mukherjee
1.Pipe tapping:2.5D-8D
2.corner/flange:1-1 inch.
3.Radius:D-D/2.
Is This Answer Correct ? | 8 Yes | 2 No |
Post New Answer View All Answers
in mass flow meter what is drive friquancy ?
I want measure the volumetric flow of gas in waste heat recovery Boiler?Tell me how and which type of instruments required. Plz mail me:naba02222@gmail.com Sam please post the answer .
List three types Level Switches with their working principles
Q1: Consider part of a control loop, which excludes the transmitter, consisting of a process, a controller and a control valve which may be represented by two dead times of 0.5 min each and three exponential lags of 0.8 min., 1.0 min. and 1.5 min. respectively. We wish to express this system as an overall first order plus dead time (FOPLD) model ie gain, time constant and process dead time. (We will see later that this is often done, to simplify controller tuning). For this exercise, gain is considered to be 1.0. (A) If the transmitter is a flow transmitter whose behaviour can be described by a dead time of 0.2 min. and an exponential lag of 0.5 min. in terms of the overall dead time and overall first order lag how can the system behaviour be approximated ? Overall dead time = Overall time constant = (B) If the transmitter is a temperature transmitter with a temperature sensor in a protecting well whose behaviour can be described by a dead time of 0.7 min. and an exponential lag of 15 min. how can the overall system behaviour be approximated now? Overall dead time = Overall time constant =
what is the field bus calble ? what are diffrences in orang colur cable and black coular calble ?
what is the protection system in solar turbine compressor
Specify eight technical requirements that you would consider important, when deciding upon a particular control valve?
what is diffrance between FF & SMART, explain with difination
What is Positive Calibration and Negative Calibration?
selection criteria of control valve? and selection criteria of actuator explain in brief?
I want to measure and control level in tank of size 10*5 filled with gasoline, so plz give me the solution with clear details. how to select transmitter and sensors.
Please tell me details about Sox,Nox,SWAS analyser????
Introduce yourself which is not present in your biodata?
i have steam drum height 1000mm. and i want to placed the transmitter below the tap.how i calculate.
What is hp & mp seperator .& what is its working principle ?