Answer Posted / anil kamat
whenever the mould is closed, there is some gap in between
cope and drag which allows some molten material to flow
sidewards when poured into the cavity. This extra material
on the final compaonent is called flash.
Is This Answer Correct ? | 7 Yes | 2 No |
Post New Answer View All Answers
What is hysteresis
Machine tool guideways are usually hardening by ?
sampile paper for dme in rrb exam
Please anyone send me previous papers of ONGC (Mechanical Engineering) at my email id jtndrkmr.vermaapril@gmail.com. Please help me.
Explain how can I see where pipes are behind the wall?
Explain the causes of the exhaust valve leakage.
Sir, I need help. I have completed dip. mech engg was working in facilties management ((Dept) for +2 yrs) in real estate, now I want to join in for mechanical industries please suggest me which should I opt for?
What is the color of flame if the boiler is running in good condition? How about when it is not in good condition?
why the wear of back tyre takes place more rapidly than front?
What parameters to be reported when we send lubricating oil for shore analysis?
What do you understand by the concept of a 6 stroke engine?
WHAT IS MEAN BY DENSITY COMPESATIVE STEAM FLOW EXPLANE?
What is the purpose of increasing the pressure on the F.O. system of the engine?
What is the use of flash chamber in a vapour compression refrigeration cycle to improve the cop of refrigeration cycle ?
Why coupling should be located very near to the bearing? Why lap joint not recommended for tensile force?