I have installed capacitor bank at secondary transformer.
cos phi is increase. but on load (far from transormer), it
still poor. Can anybody explain it??
- 6 Answers
- 11227 Views
- I also Faced
- E-Mail Answers
Answer Posted / niranajn
Because the capacitor abnk provides the ractive power
needed near a transformer but it cant provide the
kvar required by the line so the power factor is still
low
| Is This Answer Correct ? | 1 Yes | 4 No |
Post New Answer View All Answers
on a three-winding transformer relationship delta-delta-star, on third winding why the relationship is a star? what are the advantages and disadvantages? Thank you and please help
what is the formula to calculate voltage drop/loss on 66KV Transmission Line?
what are the major & minor faults that occur in an inverter and in UPS ? And how to repair and resolve them ?
how to CHECK CT AND PT AT THE FAULT OCCUR IN GENERATOR RELAY PANEL .
give me applications of sequence bridges . (used in 3 phase un balanced systems)
Why water bubbles when D.C. Current is passed through it? Why not when A.C. Current is passed?
what is KA rating and how can we choose switchgears on applications
i have seen one 8.4 MW synchronous motor in a plant located in bellary it is fixed with brushless rotary rectifier ,anybody can explain its start up principle
draw singleline diagram of star to delta and dol starters
why the NGR (neutral grounding resistor) always OFF during DG off?
what is a reactive power? what is the relation with power factor?
which is the most advanced form of SF6 BREAKER?Can we use other gases to quench the arc?
What is block diagram?
How can you calculate the size of the down conductor cable for the lightning protection system. Is 70mm2 cable can replace 95mm 2 bare copper cable when the copper tape size is 25Wx3 thk mm.
What are the three types of compensators?
