Answer Posted / j.nanda kumar
Battery specific gravity is measured with HYDROMETER.The
range of the Battery is 1150 to 1250.Fully charged
hydrometer when immersed in a battery shows 1250.
| Is This Answer Correct ? | 8 Yes | 0 No |
Post New Answer View All Answers
how to calculate voltage drop and followed by cable calculation?is there avail in formula?
What range of speed can you get with the armature control method of speed control of d.c. Shunt motor?
IF I KNOW THE AREA OF CROSS SECTION OFTHE WIRE , WATTAGE OF THE LOAD ,VOLTAGE SUPPLY WHAT IM GIVING TO THE LOAD AND ALSO POWER FACTOR OF LOAD ....... SO GIVE ME FOR WHAT AMOUNT OF CURRENT I SHOULD USE WHICH TYPE OF CABLE?
63MVA,220KV/6.9KV Transformer LV side neutral is connected to Earth pit through NGR. Whether this earth pit required to connect with near by below grouding earth mat or it is to be kept separate?
Explain about c.t?
how to test and calculat the head and discharge in borewell compressor
what is the major difference between LIBBP & HIBBP.. which one is most preferable..
What is true sine wave or pure sine wave inverter?? Is it sine wave or step wave?? If it is step wave, waves with how much step is considered as pure sine wave? Is it possible to produce pure sinewave using power electronics?
what is the need to express current and voltage in rms value? rms value is also called as effective value,what is effective value?
Define the overload capacity of the motor?
234 MVA Generator 3 phase Short circuit current Values required? Gen set Rating-234 MVA, Gen Voltage-18kv, PF;0.8, Xdv:23.5 %, Transformer Rating-18/380KV, 680MVA,Yndd1 two winding, Step up TR, ZT:35.50 %,X/R 4.33 Gen CB Position, CB open ,Disconnected open, Generator Running Voltage 18 Kv, Bi mistakes generator side earth switch Closed during that time short circuit current level in 3 Phase required, and how to test on site 234MVA Generator Short circuit current,
what is difference between earthingpits,earthing grid & earthing mess?
what is Different between Bilinear and Unilenier?
Why are short circuit ratings always 16kA,25kA,36kA and 50kA.Who has fixed these?
Can we Co-ordinate relay in Load Break switch?
