Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / gurucharan singh
Single phase energy meter, measures the power as per basic
formula P= Voltage X Current X power factor X hours.
The unit used is KWHr. This is one unit means 1000 KW power
continously supplied for one hour.
| Is This Answer Correct ? | 22 Yes | 14 No |
Post New Answer View All Answers
why single CT used in DOL starter power circuit?
how to CHECK CT AND PT AT THE FAULT OCCUR IN GENERATOR RELAY PANEL .
explain single phase series motor
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
sir please tel me how calucalte kwh if home taken load 30ams how maney kwh taken per day.and 3phase motor 5hp per hars how maney load teken and how mach kwh and forward me to electrical table for calicalte kwh and kvr and kvah
how much excitation voltage required to generate 1mw power?
Transmission voltage is kept 11KV,33KV,66KV,132KV,220KV due to form factor. What happen to 400KV and 765KV transmission voltage?
1. The DC generaror,s induced output emf is connected with a DC motor(as load). when increasing the load of the motor by using brake drum or any way. what are the parameters will changes in both motor and generator(voltage, current, resistance, frequency, speed, torque, power, flux etc...) 2. Similarly for AC generator and AC motor 3. similarly if using DC batteries instead of DC generator, What happens?
Apparent power is expressed as V * I(Conjugate). Why not in V * I ?
Why DG set is not installed in Terrace ??
one conductor length is L.and i am strech uniformly this conductor and made length is 2L.so resistance of this strech conductor is R=4R..but i want to know about area of stech conductor hows it become a/2..
In ACS 1000 drive we are using 12 pulse converter,why don't use 3 pulse converter.
An active element is one which a. Supplies energy b. Absorbs energy c. Supplies energy and convert energy from one form to another
A 11KV, 1200 A breaker combination fixed in a cubicle for HT motor.Is normally for 11 KV motor fuse is using? if Yes, What range fuse is required?
What is the maximum breakdown voltage of 11KVA and 66 KVA power line and how it is calculated?
