Interested to Buy Any Domain ? << Click Here >> for more details...
what is the effect if we add capacitor on DG supply, it has
any loss or benefit.
- 6 Answers
- 13210 Views
- I also Faced
- E-Mail Answers
Answer Posted / a.kannan
The above answer is correct And what I have experienced is
whenever we put the fixed capacitor in parallel to DG , at
any moment if load falls to certain value then consequence
KVAr (inductive ) will also reduce.Due to the fixed
capacitor the available KVAr(capacitance)is excess in the
circuit.This leads to leading current in the generator
armature circuit.Armature reaction takes place with this
leading currrent that causes excess induced EMF that
results in high voltage.this high voltage reference may be
harmful to AVR of the alternator.
| Is This Answer Correct ? | 20 Yes | 0 No |
Post New Answer View All Answers
What is CCM in Electrical ? where can we use this material?
What is the tension required for the 25000 CFM AHU belt
In ht capacitor ckt we are using LBS Panel it having isolator with fuse, one of HT fuse flash over, so what is reason behind this event.
What are the ratings of VCB, MCB, MCCB, SF6, ACB, and OCB?
5- What is the task (function) of the excitation and isolation transformers in power plant? 6- What is the task (function) of LCI (A), LCI (B) and LCI (COS) in power plant? : LCI (A) and LCI(B) are load commutating inverter for generator turbine starting. , LCI (COS) is load commutating inverter change over switch
why lightning arrestor are made in two stack of insulator but why not cvt
What will be the diameter of pipe between conservation tank and transformer
what will happen if frequency is below 50 hz?
Explain the following and how these are working with PLC Unit 1 I/O Module Card 2 Adaptor Card 3 Ribbon Adaptor 4 I/O bus 5 I/O Devices
in Telecom DC system-why positive +ve is made earthed.and - ve is fed to load.
WHATIS TIME CONSTANT? WHATIS ITS SIGNIFICANCE? ILLUSTRATE THROUGH EXAMLES.
What is the unit of attenuation?
I want to design a heating coil of 80/20 nicrome for 3.5KW please give me the calculations choosing for physical dimensions assume coil voltage will be 110V AC assume necessary conditions
Define sensitivity?
where rlc series ckt used?
