Interested to Buy Any Domain ? << Click Here >> for more details...
kindly tell me how the load on generator increase by just
increasing the fuel of prime mover, as if for exampple 20
MW gen set is synchronized the load ramps from zero to 20
MW gradully and during this procress only fuel of prime
mover increases. Which thing determines the load on
generator with respect to fuel
- 4 Answers
- 15908 Views
- Birla, I also Faced
- E-Mail Answers
Answer Posted / haribabu dasari
Any alternator share load depend up on load angle . If we
increase fuel of prime mover , prime mover drives
alternator advance in load angle ,due to this, alternator
shares more load (load is constant so load sharing between
generators only posible).if you want to load generators
you have to switch on the load switches.
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
can i use ups power as a raw power for another ups
Whether the vacuum contactor requires Short circuit protection?If No,why?
What are the disadvantages of thermal power plant?
Where is the best place to mount distribution panel in a house.
What current flows in the transformer primary when its secondary is open?
If I bring a basic electric meter from the States and hook it up in Costa Rica in a development that has only one transformer for the 50 homes, will it still be accurate regarding the usage of kilowatt hours?
Enlist four components of electrive drives.
What is an order of a system.
what is the difference between circular wdg & ractangular wdg?
what is dry and wet frequency withstand voltage? why & where it is used??
what is the difference between electrical choke and electronic choke?
How DC earth leakage currents can be reduced ?
plz send me the procedure and syllabus for mseb exam
in our all power plant have connected in grid and grid voltage and plant voltage is same, but as per as electrical concept the power will transmit from high potential to low potential but here altough same,then how power transmit from power plant to grid.
what is the purpose of slope in the differential relay?why we are using two slope?but in busbar differential we are using only one slope.why?
