WHAT IS THE DIFFERENCE BETWEEN PLC AND DCS
Answer Posted / varathan
In DCS, field I/O points can be away from the control
processor,(where as program/logic resides)its a integarted
system includes other PLC's and Stand-alone controllers for
application specific mechine or process and having large
memory for trending & Historical alarms.PLC must be a fast
scan cycle application oriented, simple system without
human meachine interface(such as process mimics/graphics)
Is This Answer Correct ? | 67 Yes | 25 No |
Post New Answer View All Answers
Draw a group of instruments interlocked to a Pump & Motor?
What is frequency factor in massflow meter? When using frequency output?
the pump holds on run indication into the dcs and filed local control panel remote push button condition operaton wrong like when the push button pushing conditions the pump is off and the push button release condition the pump is on totally opposite condition . And control room inside give the stop command into dcs just 1secon relay engage and again normal condition. How can I slove
Draw a simple circuit for a well head control panel used to protect the well against fire, leak, blockage, ESD, & controls the operation of one downhole & one surface safety valve. Explain the operation and controls
what deference between panel earth and systemearth
Draw symbols of the following :
Please tell me details about Sox,Nox,SWAS analyser????
What is zone,loop/fire alarm system?
send me HPCL paper
Explain the burnout feature.
why use 50% lel methane gas concentration for gas detector calibration instead of 60% lel gas concentration whereas the hi alarm set at 60% lel.
I m appointed as an automation trainee engineer in small firm in that I am only the one , my company give me a project on s7-200 as i m beginner I don't know how to program so please send me the helpful site so that I complete my project before deadline....please help me out in this critical situation.
Whether the DI, DOs shields can be connected with Analog Input Shield Earthpit?
What is the difference between working pressure and calibration pressure of a control valve
Is it ok, to use non-contact type Radar type LT, on a tank that is half circular from the bottom side? If yes the, isn't the waves gonna bent in other directions?