Interested to Buy Any Domain ? << Click Here >> for more details...
How do we check transformer losses and what are the ways to
minimise it.
- 5 Answers
- 15627 Views
- I also Faced
- E-Mail Answers
Answer Posted / guest
transformer losses can be found by doing open circuit test
and short circuit test
open circuit test gives the core losses
short circuit test gives the copper losses
note in open circuit test the lv side is given supply and
in short circuit test the hv side is given supply
the iron losses can be reduced by providing laminations of
thinner dimension and using c.r.g.o sheet for laminations
the copper losses depend on the winding resistance which
increases due to heat can be reduced by providing
sufficient cooling to the winding.
| Is This Answer Correct ? | 36 Yes | 2 No |
Post New Answer View All Answers
Define pole pitch?
Good morning: I'm looking for some informations about the OLTC or the LTC: I wont to know what the function of the tie-resistor in during the operation of reversing/coarse operation Cordially
Shall I use 40A semiconductor Fuses in 32 A SFU ? Frame size is same. What Happen if Fuses burn on SFU?
in cvt,there are two windings,1a,1n and 2a,2n.in my one project i use only one winding i.e.1a,1n. the other winding is not in use, so i connect it in open delta and want to close it by ibsertibg thermal resistor. the output of cvt is 132kv/115/sqrt3. plesae tell me exact value of resistor, so i may close it to avoid the resonance phenomenin. send me answer on this email adress please. aetcon-po@aetcon.com
What is the different between digital phase converter and ordinary phase converter?
what is the criterion for selecting vector group of Transformers ? i mean how to decide vector group of Generator transformer, substation trasformer and transformer at consumer end
Why do not we prefer non conventional sources of energy to conventional sources?
how to calculate the earth fault current
block diagram of 2 ups system connected in hot stand by mode?
-What shall be short circuit current of LV switchgear for a 1000 kva, 11.415kv, 3 phase tranformer with 5% reactance.
how we can do the insulation on secondary of ct explain and so that tan delta will within limit
How to calculate the phase to phase clearness of HT /// LT bus bar?????
I want definition for ABT Meter (Availability Based tariff) ?
condition Autotrip facia come on control panel of electrical transmission line?
Name two low frequency oscillators?
