WHAT IS THE DIFFERENCE BETWEEN PLC AND DCS
- 55 Answers
- 113302 Views
- ABB, Adani, Adani Power, GMR, IIUC, I also Faced
- E-Mail Answers
Answer Posted / shan
The difference between DCS and PLC is that, PLC is
primarily a small scale control system which only executes
only digital function. When we say DCS, It is a networks of
PLC's,it is a large scale control system which is
distributed all over the plant,and is located in a control
room.
| Is This Answer Correct ? | 60 Yes | 62 No |
Post New Answer View All Answers
What is mean by analytical instrumentation?
How to control flow variations in magnetic flow maters..... When i will provide proper earthing?
Can anyone send most commonley asked Instrumentation questions and answers in cement industry please?
Galvanizing.
What is the difference between working pressure and calibration pressure of a control valve
what is the diffrence between pressure safety valve & pressure relief valve....pls
few questions on RS 232,1 question on relationship of impedance and turns ratio, many questions on flowmeters
I will attend an interview with GasGas company for a position of Instrument Technician ( Offshore )in next month can anyone tell me what questions they will ask. Thanks in advance.
If fire would be inside the plant which fire detector is to detected the fire.
Why humidity limit is 30 to 55 % for raw material storage?
how to do dynolab wind speed sensor loop test, how to simulate value,i have simulate mA 4-20mA but not responding in DCS faceplate, please kindly advice me any one.
where proximity sensor installed on tank in loading arm application
i have done DAE in Instrumentation and Process Control. i have applied for an apprentice training in chemical company after three day my interview will be conduct but i need more information about industrial process control and controller. my e mail is imran_dilsetu@yahoo.com please tell me interview question relative to instrumentation ?
Give 2 application of quartz crystal used for process parameter measurement.
if in a level tx height is given, how u calculate the ranges of the tx?
