Interested to Buy Any Domain ? << Click Here >> for more details...
Two 11 kv lines are feeding to common bus in a
substation,I have one set of CT & PT(3ct,2pt), How can I
measure both lines power using single set.
- 6 Answers
- 12090 Views
- L&T, I also Faced
- E-Mail Answers
Answer Posted / raman jain
As 11 kV feeder is concerned , the load is more or less
balanced . So put one PT and one CT on R-Phase of each
line , and one can measure the power on bith feeders
approximate but not exactly.
| Is This Answer Correct ? | 1 Yes | 5 No |
Post New Answer View All Answers
how we start 40w tube light with 4 diodes,2capacitors,1 choke and without starter.(a product avilable in market which lights burnt tube lights also)
one split ac how can told of this ac which Tr tell me us
Damping resistor provided in open delta (tartiary) winding of a measuring PT at the incoming of a MV inverter drive panel is getting heated up. Can any body explain the reasons and suggest the remedy?
Approach of a cooling tower is the difference between temperatures of what factors?
How to calculate approximate load loss of a distribution transformer by knowing %ge imp of transformer?
how to test the electrical panel.ht lt mcc pcc.
54 Comments Alok and Bhanu play the following min-max game. Given the expression N = 38 + X*(Y – Z) where X, Y and Z are variables representing single digits (0 to 9), Alok would like to maximize N while Bhanu would like to minimize it. Towards this end, Alok chooses a single digit number and Bhanu substitutes this for a variable of her choice (X, Y or Z). Alok then chooses the next value and Bhanu, the variable to substitute the value. Finally Alok proposes the value for the remaining variable. Assuming both play to their optimal strategies, the value of N at the end of the game would be?
As per standard, transformer body earthing and other Equipment earthing (Equipment earthing) did not connect. but in LT side termination we are doing metal glanding in both side Transformer to PCC Panel through armoured cable, now X'mer body earthing and PCC Pane earthing (Equipment earthing) both are connect.is this safe for X'mer or other equipment?
What is the rate of WCT on the Electrical Contracts comprising of DG Sets and Civil Works in Delhi ?
we have a 2.5hp Starite electric motor water pump,the elec motor burned out,we need to replace starting capacitor(old capacitor specs erased),what microfarad rating capacitor do we need? 110-125V
How much depth n width required for laying of 1X70 Sqmm Cable in Desert???
How do you determine the size of transformer radiators in a transformer?
What is an iron loss or core loss pi?
3 shows a 415 V, 3-phase generator supplying a 3-phase 415/110 V transformer. Draw the individual and combined impedance diagrams to a base of 10 kVA. Determine the system fault kVA and the fault currents at the 415 V and 110 V busbars for short circuit faults on the transformer input or output terminals. Work in p.u. values of impedances.
block diagram of 2 ups system connected in parallel mode?
