Answer Posted / mm
the anti pumping device is used to avoid continously
energising the breaker closing coil once the CB has already
closed. this is done to avoid burning the coil
Is This Answer Correct ? | 85 Yes | 12 No |
Post New Answer View All Answers
WHY THREE PHESE SYSTEM VOLTAGE APPLIED IN 440 VOLT
How to calculate energy stored in an inductance?
what is KSR type transmission tower? What is LSR type transmission tower?
how to find the torque of the single phase synchronous motor by doing an experiment
what will happen if frequency is below 50 hz?
Is it possible to operate a synchronous 2-poles turbogenerator with a still-in-place faulted bar but electrically disconnected ???? If yes, should I act on the other phases as well ???
What is current & voltage ? Voltage perform at any load without current or not?
how to design coil turns ?
What is a slack bus?
difference between a diode and thyristor?
why we use ac supply as 415 volts instead of 415 v why we cant apply 230 v for dc
what is reverse power relay brief explanation and in b/w where it is connected
Why does the speed regulating system adopting I controller have no steady-state error? In this single closed-loop speed regulating system, when the input of the I controller Un=0, what is the output voltage of the regulator? What factors do the output voltage depend on?
Why induction motor is widely used in industry
What is meant by reset level of the relay?