what is hormonics. how it is generated & what are the
problem faced by that.
- 5 Answers
- 11788 Views
- APC, I also Faced
- E-Mail Answers
Answer Posted / graeme
Harmonics are frequency components that are whole number
multiples of a fundamental frequency. For example, in a
60Hz AC supply system, 2nd harmonic is 120Hz, 3rd harmonic
is 180Hz and 4th is 240Hz.
Harmonics are most often caused by non-linear loads (eg
transformers where the line current is distorted by the non-
linear B-H characteristics in the core), rectifier circuits
and phase control circuits. In all these cases, the
resulting load current waveform is not a pure sine wave, so
harmonics are present.
Harmonics can cause all sort of problems such a voltage
waveform distortion and the different harmonic frequency
components causing different impedance values to appear in
reactive components.
| Is This Answer Correct ? | 10 Yes | 1 No |
Post New Answer View All Answers
3 phase Motor will be given 2 phase after 2 to 5 second we given 3rd phase so Motor Run sum-time in forward or sum time run reverse direction. All time phase sequence is not change. Why motor run in reverse direction? Please Explain........
What is the estimated total hydropower potential of india?
why are installed water leakage detection system data centers & server rooms
My question is whether bellow formula is correct to find bus size for 46kA for 0.5 second & what is RT in bellow formula. formula to calculate the size of busbar to withstand the thermal stresses due to currents with duration of 0.2 sec to 5 sec. Sp = RT( I x I x t) / K Where Sp – is the cross sectional area of bus bar in millimeters. I - is the value of AC fault current. t - is the operating time of disconnecting device in seconds. K – is the factor depending on the material of the conductor, insulation and initial and final temperature. Value of ‘k’ for copper is 143.
What is the necessary condition for stability.
boiler is running in rankine cycle and deisel generator is....?
what is rocking arrangement in arc heating
give single line diagram of D.G distribution form alternator to main L.T panel?
in shunt clippers why a resistor is used in sereis with the input
i am studying in final year can i allowed for 23rd UES of Indian army
why we take movement of rotor always in counter-clockwise direction in 3-phase induction motors?
why only exciting current is shown not primary current in transformer???
What is your acheivements
How Calculet The UPS AH In Load
Can we Co-ordinate relay in Load Break switch?
