Explain why machinery used on a.c supply is usually rated
in KVA instead of KW?
Answer Posted / bhanu pratap pal
Because the power factor of the machinery is not a constant
parameter i.e. it varies with the change in the supply,
hence the rating of machinery declares in KVA.
Is This Answer Correct ? | 4 Yes | 10 No |
Post New Answer View All Answers
what is the function and use of cable differential protection relay?
What is the rating of circuit breaker needed for 300 KVA load in 33 KV supply line in a transformer of 33 KV / 415 Volt ?
What are IP protections used for electrical panels, JB, equipments installed in explosive zones like Petrochemicals, Oil & gas
How many turns are there in primary winding? (In Transformer)
How much current will a 5 HP delta connected motor at no load will take?Is tat need a starter
why +24 v and -48 v give to BTS? If -48v protect from surge then why we not use -24 v?
Diagram on interconnectivity of 11kv transformer with RMU (i.e, one incoming and two outgoing or two incoming and one outgoing)
Draw transformer phasor diagram.(full load,no load)
why does a dc machine has high efficiency while working as a generator than as a motor ..
Define liftable weight of a transformer? Does the total weight of transformer include oil weight?
What magnetic circuit is formed in berry-type constructions and why?
what curve and rateing would you use for a three phase 0.75kw motor?
for 100 HP Induction motor service factor is 1.2(SF) we placed a VFD at the motor side load is balance with 0.3 Amp's Phase to Phase but at incoming of VFD load is un-balance with 10 to 20 Amp's what will be cause of load un balance
I am having dual speed motor of cromton greaves make of 3.7 KW -1400 rpm and 5 KW - 900 rpm. Please let me know groups and winding connction for rewinding purpose.
What are the causes for the failures of sandwich type (Al) busducts?