Interested to Buy Any Domain ? << Click Here >> for more details...
Explain why machinery used on a.c supply is usually rated
in KVA instead of KW?
- 10 Answers
- 22827 Views
- EEE, Mtandt, I also Faced
- E-Mail Answers
Answer Posted / mani2089
kw = kva * power factor
The power factor affects the maximum demand component of
the network charges. Generally, kva demand tariffs are
structured to be revenue neutral compared with kw demand
tariffs at a power factor of 0.8
| Is This Answer Correct ? | 9 Yes | 6 No |
Post New Answer View All Answers
For an induction motor wat is the loading/unloading cycle duration or interms of L/UL ratio/ percentage?
I WANT TO know WHICH WAY IS BETTER FOR CONNECTION BETWEEN POWER TRANSFORMER AND MAIN DISTRIBUTION PANEL. 1-IS BETTER WE USE CABLE? 2-IS BETTER WE USE BUS DUCT? my transformer rate power is 2500KVA
What happens if we run alternator on under frequency?
WHAT IS DIFFERENCE BETWEEN CAPACITOR AND CAPACITANCE?
Can anyone explain me about the capacitor calculation
why do we have spikes enough to burn electronic boards, when generators are not grounded
We are preparing another project which involves Waste heat recovery from a 1 MW GE Engine. The Engine in particular gives out flue gas at 487Deg C with a flow rate of 5650 kg/hour and this can be cooled to 180 Deg C. This gives a thermal output of ~ 594 KW that is available for input to VAM via heat exchanger / boiler. Additionally 581 KW will be available from engine jacket water (temperature profile 80/ 80 Deg C and a flow rate of 50m3/hr) Our estimation is that 300 TR of cooling is possible with a suitable VAM machine(s). Please advise what is the most suitable arrangement with maximum TR and min Capital expenditure. plz reply me as early as possible
transformer spections :: input voltage 0-110-230v; output volage 0-10-12-14v; amp=3A using CRNO CORE, capcaity=50VA primary turns = ? ; secondry turns =?
What is the significance of integral controller and derivative controller in a pid controller?
in control scheme dc logic wiring commonly using negative loop,what is the reason?if we use positive looping what will happen?
i will applied in 1U-1W on 440 volt primary delta side. what is the result of magtic balance test
operation of diesel generator
What do you understand by avr?
sir& friends i want the collection of recent quetions asked in interview of top most companies please send me on my email san.jsr@hotmail.com
What are the advantage of free wheeling diode in a full wave rectifier?
