11kv/0.433kv, 2 mva , transformer , for protection and
metering how many CT/PT are required?
Answer Posted / k n naidu
hi,
one three phase set of PTs for both protection & metering
and one three phase set of CTs with two secondary cores one
for metering and protection are required.
Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
WHAT IS MEANT BY INSULATION CLEARANCE IN VACCUM?
What is the requirement of grounding the neutral of single phase generators on load? If the neutral is not grounded, what will be the effect?
I WANT HOW CALCULATE TO CABLE FOR WELDING PLANT ?
block diagram of 2 ups system connected in hot stand by mode?
What is voltage ratio of a transformer?
How we can calculate the life of Lead acid battery
Draw a 230kv two-bus bar system showing the following. 1.Two generators (150MW) each connected through one 15.75/230KV transformers 2. 1 outgoing lines 3. Two 230/130 KV transformers 4. BUS PT's 5. CT
How to test the Secure Elite 440 Multi function meter working condition.
When will you multiply and devide with derating factors to the actual value while sizing the cable?
Power Factor Correction Panel (Manual & Automatic)
how to electrically make connection to ferroli GN2N?
How much voltage we need to apply in 33kv cable during hipot test of cable
explain me the relation between torque, frequency,speed,voltage and current in the 3 phase induction motor?
Why 30kw 40 hp 4 pole 3ph induction motor over heated?any steps on reduction in heat?
Explain about technical and non technical losses in distribution system?