Interested to Buy Any Domain ? << Click Here >> for more details...
in three pin pluge there three pins one is phase and second
is earth third is nutral why nutral high diameter compare
with phase and earth
- 10 Answers
- 19233 Views
- Radiant, I also Faced
- E-Mail Answers
Answer Posted / vinod bhardwaj
nutral pin always more dia compare than the phase & earth
pin
beacuse current always follows the low resistance path
beacuse of more dia it have large area compare than other
pins .if area is more lesser will be the resistance
beacuse resistivity =resistance*length/area
in case of any short ckt current always current rise
abruptly hence low resistance path provide the easy & fast
flow to current
| Is This Answer Correct ? | 3 Yes | 24 No |
Post New Answer View All Answers
for hipot test on 33kV busbar, we will test on 70 kV or 56kV, what is the acceptable leackage current?
At full load wat is the motor p.f And at no load will is the motor p.f?
how you taken aotitude test
how to calculate sizing of NGTR (Transformer rating,Loading resistor value and Current rating of resistor) and what is the X/R ratio. Details : 11kV,Capacitance 1.73532 micro farads,40kA for 1sec.
What is pole of the system?
How u can give the overload setting to any motor protection relay for a HT motors with formula and Example?
If we need 4c× 50mm sq cable but it's not available so we can pull 4c×25mm sq two cables?
What happens to voltage when current through the inductor is constant?
How can we calculate the KVA rating of a Distribution transformer from its core details?
why would amp draw on neutral wire be as much as amp draw on the hot leg.
what is meant by LCR meter? where its useful ?
why do we use spark detector inside the slip ring brush compartment 0ona slip ring induction motor?
Is it a better option to procure screw type air compressor rather than reciprocating air compressor?If so, what is the reason?How should we select an air compressor(100 CFM)? Please mention the important parameters of air compressor.
If we have 11 kv RYB Phase single core cable near about. Then wht effect and losses
Two electric lamps 40 W, 220 V each are connected in series across 220 V. What is the power consumed by the connection?
