Interested to Buy Any Domain ? << Click Here >> for more details...
HOW DO YOU PROVE THE HIGH VOLTAGE CABLES OR BUSBAR IS DEAD
EVEN AFTER IT IS DE ENERGISED
- 6 Answers
- 15140 Views
- I also Faced
- E-Mail Answers
Answer Posted / hassan
BOTH SIDES BREAKER OPENED , DE-ENERGIZED AND EARTH APPLIED.
| Is This Answer Correct ? | 7 Yes | 3 No |
Post New Answer View All Answers
Define active and passive network?
What will be the effect if I use inverter as UPS mood?
Hi, Next week Iam appearing RRB exam for section engineer. So help me to get modal question papers for this position. Iam very thankful to you. Whether question will be fully techanical format or general form. Please give me a details regarding this exam.
What are protections for dty type transformers
how to calculate energy of 3-phase motor?
Why insulation level follows this order? transformer < bus bar < circuit breaker & Isolator < transmission line.
what is the working principle of a DG Set, Alternator, & exiter
How PSV sizing being done
I need bhel previous year quetion papers for electrical engineering department.I searched but i could not find out
What mean by MLTP
what is vtg limit of earth and neutral at transformer side?
what is acceptable leakage current for 33kv cable while doing high voltage test for cable? how to calaulate the leakage current for 33kv or any rated cable?
1)what is the function of a frequency inverter? 2)If a few frequency inverter are connected onto a device network,what are the two setting that will ensure the frequency inverter work properly on the network. 3)whats is the name of the input sensor for weigher? 4)How to confirm that the load cellis faulty? 5)Describe briefly the steps to validate that the weigher is working properly? 6)Describe the procedure to validate the flowmeter accuracy? 7)Describe briefly the steps to validate that the tempreture sensor/transformer is working properly. 8)what is the adjustment that need to be done when you are calibrating the temperature transmitter ? 9)what are the safety measures to be taken before disconnecting motor for rewinding. 10)whats is the synchronous speed in rpm of typical 4pole 50hz motor? 11)whats is the formula for kw, ohm's law 12)if a 3phase motor is rated 3kw,415vac,what is it's rated ampere?
How cable from Kit-Kat to main switch, from starter to motor are designed?
why chock were used in old tubelights but are not newest tubelights?
