Interested to Buy Any Domain ? << Click Here >> for more details...
how to control the generator output voltage?
what r the condition should satisfy for synchronization?
- 7 Answers
- 27201 Views
- HP, I also Faced
- E-Mail Answers
Answer Posted / rvg.msceb
to be very clear, in commercial generator, nobody using
separated excitation system. self excitation is the best
method unless some specific reasons.
For controlling output voltage, a device called AVR,
automatic voltage regulator to be used, and it sense the
output voltage at each instance, and adjusts accordingly.
these are the condition for syncronization.
1.phase sequence of both generators should be same.
2-frequency shuld be same.
3-terminal voltage shuld be same.
4.both generators should have nearly same percentage
impedence.
| Is This Answer Correct ? | 24 Yes | 1 No |
Post New Answer View All Answers
what is conductor copnstant of ab cable
does any one know where we can purchase insulation oil for high voltage oil filled cables
Pleae send me last 5 years of Question book about RRB chennai.
ELECTRICAL DRIVES: can a motor load system with passive load torque can have equilibrium speed in second quadrant
What will be the fault current of any system when its generation is 10% of BASE generation( FUll Load )?Will is 10% or the same as full base calculation?
A 3-PHASE TRANSFORMER IS USED TO STEP-DOWN THE VOLTAGE OF A 3-PHASE, 11KV FEEDER LINE. PER-PHASE TURNS RATIO IS 12.FOR A PRIMARY LINE CURRENT OF 20A, CALCULATE THE SECOUNDRY LINE VOLTAGE, LINE CURRENT AND OUTPUT KVA FOR FOLLOWING.A)STAR- DELTA.B)DELTA-DELTA.
what kind of technical test that i need to learn because i have an interview tomorrow.. please someone help me..
Dear all, how we select the cable size according to current with or without including different correction factor , is there any direct method for sizing of cable...
What is A check, B check, C Check & D check for a diesel Generat
i need some project topics along with circuit diagram in the electrical adnd electronics engg and also give ome website regarding projects.my mail id is thenmozhi2k7@gmail.com .please help me.
Which motor connection is preferable star-delta or delta-star?
what the Microsoft .NET framework is?
the site measured knee point voltage of protection class CTs should be greater than rated knee point voltage? what about meetering class CTs. Should it be below the rated knee point voltage?
what should be the acceptrd value of winding resistance for 2.5MVA transformer
What is the general system requirement of alternator?
