Interested to Buy Any Domain ? << Click Here >> for more details...
Do you know how to joint the H.T and L.T Cables?
- 23 Answers
- 63643 Views
- KESC, MGVCL, Nokia, Oil Country Tubular, Power Control, SAGT, Siemens, Simco, Vivek Engineers, I also Faced
- E-Mail Answers
Answer Posted / dilip b shah
H.T cable joint can be done by two method.
By Heat shrink kit or by m seal kit.If cable is unearth
prefere to use heat shrink kit. in earth cable prefere to
use m seal kit.
Two L.T Cable joint done by m seal kit(low voltage kit)
and end termination done by bimatalic lugs.
| Is This Answer Correct ? | 22 Yes | 19 No |
Post New Answer View All Answers
what is the formula to calculate voltage drop/loss on 66KV Transmission Line?
What is the unit of magnetic flux density?
What is the permissible maximum flux density in transformer core?
Enlist four components of electrive drives.
In a 3 phase 4-wire system. For a 3.5 core cable if all loads are single phase and balanced, what will be neutral current? will it be sum of all phase currents? Or it will be zero? And if loads are unbalanced what will be neutral current?
What are the types of class b amplifier?
Vaccum circuit breaker
advantages & disadvantages of Lagging and leading power factor .
How to calculate the heat load for a electrical room
can we use NPT glands in LT panel
what is photo voltic cell,& what are the materials associated with that?and any spcifications like volts/cm etc?
Why synchronous motor is used in power factor improvement,dc series in lift
how power trnafor from 1 point to another point in bus bar ya transmission line( voltage trnasfer from 1 point to another poin)
What is the formula for calculating the Instantaneous Short Circuit & overcurrent for any breaker
Which power will flow first if we switch on a motor Active or Reactive? How?
