We have 800KW motor operating at 6600Volt,50 Hz
supply.During 1st startup it tripped on overcurrent
trip.It's FLA is 88 Amps.The K factor of Thermal overloaaad
was set on .94 initially.then we set at 0.97 and then it
started fine.i dont understand why it tripped first?What
are the protections which comes in picture during starting ?
- 6 Answers
- 10134 Views
- I also Faced
- E-Mail Answers
Answer Posted / kiran patil
You have increased thermal overload settings to .97 I think
because of load motor gets hot early and after incresing
the themal rating it will sustain.
| Is This Answer Correct ? | 5 Yes | 5 No |
Post New Answer View All Answers
what is the condition for YnD11
how to avoid electrical shock how capacitor store charges wat are the speed control of induction motors state faradays law flemings left hand rule what is rotary converter wat is transmission and distribution what are the sources of energy abrevation of acb,vcb,sf6,igbt what is output equation of transformer which test copper iron and iron loss are calculated what is eddy current draw a single line diagram (10 marks) draw direct online starter(10 marks)
PLZ sent the previous year question paper for GET in NHPC on my EMail id ppshanker@gmail.com
Draw the line diagram of diffretial relay connected to transformer?
I want single line diagram for AMF & DG syncronizing panel
What products have you designed which have entered high volume production?
if any body have question paper of railway (section engineering),then plz send me .i will thank of him/her.
sir pls send the je exam - 2008 and other model question papers..
all the technical question with answers pleas send your email id ramar_eee@yahoo.com
how you will decide the distance between the power transformer and its fencing
Is it possible to measure correct value of earth resistance & cable insulation ristance with out disconncting earth lead & both sides of cable ends? If not, any other method to measure ER & CIR with out disconneting from the system.
can i able to get bhel previous exam question paper?
Draw the vector diagram and condition for the following: 1) Dyn1 2) Ynd0 3) YnYn0
can you please send me the technical questions and aptitude questions of honeywell and jindal steel electrical engg. question paper my e-mail ID is(kkesavanraj@gmail.com)
Draw a block diagramof Three UPS systems connected in Parallel mode?
