Interested to Buy Any Domain ? << Click Here >> for more details...
What is the effect if power factor is above 1 or unity.
- 15 Answers
- 49848 Views
- NTS, I also Faced
- E-Mail Answers
Answer Posted / gajanan
at unity power factor all active power used so it is real
power and reactive power will be zero so losses will be
zero.
but power factor never goes above unity as it is cosine of
angle between ph diff of voltage and current
and
cos0=1(unity)
(note: Provas plz can u describe)
| Is This Answer Correct ? | 73 Yes | 20 No |
Post New Answer View All Answers
What is true sine wave or pure sine wave inverter?? Is it sine wave or step wave?? If it is step wave, waves with how much step is considered as pure sine wave? Is it possible to produce pure sinewave using power electronics?
at what base you will tell the direction of rotation of dc motors and generators?
The loads are connected with phase and ground then why current flow as the loads ?
what are the different sizes of U.G. cable & where these cabl;es are used according to voltage ..
Convert a star connected network into a delta connected network.
what is strip power factor?
How vfd saving power.
In hydel power plants, L.A's, S.C's are placed inside the control panel boards. what is the purpose? [already the total body was earthed to ground.]
A 3 phase transformer's (Y-Y) Y and B phase is (Y and B connection not broken) broken from neutral and R and Nutral connection is ok, what will be the relay tripping and why
i have install 750 kva distribution transformer at my site and want to do neutral earthing. what calculations should i follow to determine earthing conductor material and size?
Dear all, I just want to ask an expert on this forum for some insights. For the magnetic balance test, when applied voltage on a Delta-Star transformer e.g. Dyn11, the following relationships apply for HV side: 1. H1-H2 = H2-H3 H3-H1 2. H2-H3 = H3-H1 H1-H2 3. H3-H1 = H1-H2 H2-H3 For the LV side also: 4. X1-X0 = X2-X0 X3-X0 5. X2-X0 = X3-X0 X1-X0 6. X3-X0 = X1-X0 X2-X0 Is there a similar pattern for Y-d, Y-Y, D-d? And how about Y-z, D-z, Z-y transformers? I've tested a YNzn5 transformer and for LV side I don't see the pattern. In this particular case I got for LV side the following (see values below): H1-H0 H2-H0 H3-H0 X0-X1 X0-X2 X0-X3 128.0 119.9 7.2 29.2 13.3 15.8 70.7 128.4 59.2 23.4 22.0 3.6 7.2 120.1 128.1 13.4 29.3 15.8 What is the relationship here for LV? For row 1 I see the relationship, for row 3 I also see but it's shifted, but for row 2 I don't see such relationship. Any suggestions, answers, someone?
Please elaborate th´evenin’s theorem?
What is Bolted fault?
Name two low frequency oscillators?
HOW DO I CALCULATE THE SETTINGS FOR THE DIFFERENTIAL PROTECTION OF A 12kV/6.6kV, 6MVA,DYN11 XMER WITH PRIMARY SIDE CTR 400/1 AND SEC SIDE CTR 600/1?
