Interested to Buy Any Domain ? << Click Here >> for more details...
Why we should use delta connection in primary and star
connection in an distribution transformer, which converts
400v a.c. voltage to 33kv.
- 15 Answers
- 49190 Views
- ABC, Kirloskar, Sify, I also Faced
- E-Mail Answers
Answer Posted / r m koloi
we dont need nuetral at primary side but it is needed at
sec. side because some loads of 3 ph and single phase loads
required nuetral.
| Is This Answer Correct ? | 45 Yes | 19 No |
Post New Answer View All Answers
Which device of PlC does share load between DG sets when DG are running in perallel?
What is the maximum number of swithes that can be connected in series up to down stream point in an LV Distribution system?
Why efficiency in thermal power plant is low?
What are the advantages and disadvantages of the ac motors?
Dear Respected sir how to test ABB REX521 protection relay by relay tester.
how to calculation increase capacitor,increase power factor for three phase.
what is meant by twilight switches 7 where its applicable ?
I COMPLITED MY B.TECH AND 10TH CLASS WITH 70%MARKS BUT 12TH CLASS 55%MARKS..CAN I GET INDIAN RAILWAY RECUREMENT EXAMINATION?
why transmission is only 3 phase and not 2 or 4 or poly phases
A car's starter motor draws a current of 100 A at 12,0 V when starting the engine. The mechanical power required to turn the engine is 960 W. At what rate is energy from the battery converted to non-mechanical forms of energy?
What is the need for a controller?
i will applied in 1U-1W on 440 volt primary delta side. what is the result of magtic balance test
What is phenomenon of electromagnetic induction and how it works?
What is the maximum percentage voltage drop (vd%)for a motor control center
What is contract demand in solar system?
