Interested to Buy Any Domain ? << Click Here >> for more details...
Can anybody explain Why starters are not used for motor
starting in industries?
- 9 Answers
- 11662 Views
- I also Faced
- E-Mail Answers
Answer Posted / nilkanth
IN industries rating of motor is very high and there is
high voltage is used there for high starting current is
required.thats why starter is not used in industres.
| Is This Answer Correct ? | 2 Yes | 12 No |
Post New Answer View All Answers
how invertor convert the dc into ac give brif detail
WRITEDOWN FEW RELY CODES
What range of speed can you get with the armature control method of speed control of d.c. Shunt motor?
What is stacking factor? What is its approximate value?
which fault is severe and why?between lll fault and lllg fault which fault is severe and y?
What are IR values and what it should be for coil and for insulator
what is the function of anti pumping relays? what is KVAR? How it is generated in alternator? What is 3rd Harmonics? What is IDMT relay?
Proviiding the Dedicated N earth and individual Body Earths ,Finally these all looped /Now my Question :- will it not harm in case of Transformer Fault current flows in Dediacted N Earthing to Looped Body Earthing.
1 “earthing” for bonding of equipment and circuits to common plant earth electrode potential, 2 “protective earthing (PE)” when this bonding is required for personal safety provisions 3 “grounding” for interference suppressing bonding of screens, sys-tems with ground level 4. low-impedance earthing ? 5.primary earthing system and secondary earthing system what is that? 6.earthing electrode or mesh net earthing electrode ? very confusing , simple but very informative help required ? i will be very very thankful to you guys.
neutral earth resistance testing is it possible for transformer while in load condition
i will applied in 1U-1W on 440 volt primary delta side. what is the result of magtic balance test
i m electrical diploma holder i want to do plc $ Scada some body tell me which insitute is best for me near chandigarh
what's prime importance of protection in electrical system.if protection system don't work properly what can happen in electrical system?
What is the basic principal, by which DC voltage level is increased more than the supplied AC voltage during conversion. As upto AC level it is contorrled by firing anlge but after maximum level how is it possible.Please clear picture. OR we have to supply the higher level AC?
What is the efficiency during maximum power transfer?
