kindly tell me how the load on generator increase by just
increasing the fuel of prime mover, as if for exampple 20
MW gen set is synchronized the load ramps from zero to 20
MW gradully and during this procress only fuel of prime
mover increases. Which thing determines the load on
generator with respect to fuel
- 4 Answers
- 14428 Views
- Birla, I also Faced
- E-Mail Answers
Answer Posted / rvg
The load on the generator means,the line current draws from
the generator. Pls be remind that, generator is an energy
converting device, which converting mechanical energy to
electrical energy.
As soon as more current draws from the generator,the
mechanical load on the prime mover also rises. SO that, more
fuel consumption takes place.
| Is This Answer Correct ? | 12 Yes | 1 No |
Post New Answer View All Answers
kindly send me 11KV MV motor differential protection procedure by primary injection method.
PLZ EXPLAIN CORONA,SKIN,BIRD PALE,SPAN,SAG Effects of power cable.
What are gain margin and phase margin?
what are pilot cells
derive DC RMS value for half wave rectifier?
i have been tasked with a design of protection, metering and control(PMC) relay panel extension to accommodate all PMC relays.There is an already existing panel where this one will be built.What are the design aspects for this kind of project? thank you.
what is the excess air in furnace
What is hipot test procedure?
How much inductance or resistance require as a starter in series with induction motor of specific capacity(e.g. 5 hp) ? What is formula for it ?
please send 5yearje solved papers on my email himmatsinghnathawat@gmail.com
how does a submersible pump work..?
can any one suggest paper presentation topies for electrical engg?
Hi, My plant daily consumption is calculated as 3.8MWH but my supplier has sanctioned an power of 2.6MW per day. how can i equal or distinguish this two factors
How will A Medium voltage circuit breaker(11 kV voltage level) operate under short circuit fault condition whether It is having short circuit release like Low voltage circuit breaker or relay should be given?
what is v/f control in VFD?
